Multi Functional Marking Equipment

>>> Home > Products > Equipments > Multi Functional Marking Equipment


Multifunctional Marking Equipment
Model :	RST-3000M

A truck mounted striping machine capable of melting and applying two lines of pre-melted thermoplastic. Applies either a solid or skip pattern or combination of these patterns, and of simultaneously or separately applying a center and edgeline mark. Raised-rib and Extrusion line application also available.

- Electronic Skipline System.
- Glass Bead System.
- Hydraulically Agitated.
- Thermoplastic Ribbon Guns(Extruder)
- Raised-rib application Shoe.
- 1,200 kgs. material tank is oil jacketed and pressurized.
- Hydraulic agitation is provided by two mixer paddles to prevent bead    settlement.
- Thermostatically controlled with pilot safety valve and electronic iginition    system.

     Need more detailed story for Raised-rib line marking system?
                                              Go to HERE

1. Prime Mover Vehicle	:	Dependant on chassis selected
2. Compressor Type Output Pressure Maximum Speed Engine	: : : : :	Airman 175 175 cfm 100 psi 2900 rpm Diesel engine
3. Heater Type Output Electrical System Fuel Ignition & Flame Failure	: : : : :	Double Coil Vertical Heat exchanger 90,000 BTU 12 V Propane gas Constant Spark
4. Heating System Heat Transfer Pumps Tubing Thermostatic Control Pressure Relief Valve	: : : :	Hydraulically Driven Geared circulation Pumps Metal Braided Flexible BSP Connections Automatic Mounted in Control Bank
5. Material Tank Tank Test Pressure Working Pressure Capacity Agitator Safety Valves Insulation	: : : : : : :	Pressurised 1.058 N/sq mm 0.6895 N/sq mm 640 Litres (1280 Kilos) Hydraulically Driven Ball and Spring type Ceramic Fibre Blanket
6. Bead System Tank Test Pressure Working Pressure Capacity Filler Air Supply Safety Valves Application	: : : : : : :	Pressurised 110 psi (7.5 Bar) 50 psi (3.5 Bar) 91 Litres (20 Gallons) In Line Type Ball and Spring Type Pressure fed gun attached to carriage
7. Control Console	:	Designed containing all instrumentation for application unit.
8. Pattern Generator Gun Selection Power Pattern Selection Transducer	: : : :	Two 12 V Electronic System Variable with infinite range Radar Velocity Sensor
9. Marking Units Carriage Designed to follow pavement contours Polyurethane tyred wheel
10. Extrusion and Raised rib Shoes Multi Width Extrusion Shoe 100mm - 200mm 1 unit Raised rib Shoes 100mm I unit 150mm I unit All fully Oil Jacketed
11. Bead Guns Near Side 2 unit Off Side 2 unit Even distribution by air pressure. Synchronised to operate with material gun. Hardened spray nozzle and needle tip.
12. Electric Supply Alternator charged on prime mover and compressor engine.
13. Fuel Supply Diesel Independent supplies for prime mover and compressor.
14. Hoses Designed to give uniform cross-distribution of material.
15. Safety A. Caution or Line Painting written to front panel of Prime Mover. B. Amber flashing lights mounted to rear of vehicle.

Extrusion
	Raised-rib Marking
Sprayplastic

Above specifications are subject to change without prior notice.
Medium sized equipment available.